Indicator Circuit: Procedure

1. Turn the power switch OFF.
2. Connect the Techstream to the DLC3.
3. Check the ECUs connected to CAN bus. Refer to DIAGNOSIS SYSTEM .
   RESULT
   
   

   Result	Proceed to
   No malfunction appears	A
   Malfunction appears	B

B → See step   6 

A: Go to next step 

1. Turn the power switch OFF.
2. Connect the Techstream to the DLC3.
3. Check for all DTCs.
   RESULT
   
   

   Result	Proceed to
   DTC is not output	A
   CAN system DTC is output	B
   LIN system DTC is output	C

C → See step   7 

B → See step   6 

A: Go to next step 

1. Turn the power switch OFF.
2. Connect the Techstream to the DLC3.
3. Turn the power switch ON (IG) and the Techstream ON.
4. Enter the following menus: Body Electrical / Combination Meter / Active Test.
5. Check the condition of the absorber control indicator light and height control indicator light by operating the Techstream.
   COMBINATION METER
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Indicat. TEMS Sports	Absorber control indicator light (SPORT)	ON or OFF	-
   Indicat. Height High	Height control indicator light (HEIGHT HIGH)	ON or OFF	-
   Indicat. TEMS Comfort	Absorber control indicator light (COMFORT)	ON or OFF	-

   OK

   Indicator light turns on when operating the Techstream.

NG → See step   8 

OK: Go to next step 

1. Turn the power switch OFF.
2. Connect the Techstream to the DLC3.
3. Turn the power switch ON (IG) and the Techstream ON.
4. Enter the following menus: Chassis / Air suspension / Data List.
5. Select each item below in the DATA LIST and read its value displayed on the Techstream screen.
   AIR SUSPENSION
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   COMFORT Switch	Absorber control switch (COMFORT) / ON or OFF	ON: COMFORT OFF: NORMAL	-
   SPORT switch	Absorber control switch (SPORT) / ON or OFF	ON: SPORT OFF: NORMAL	-
   Damping Force Switch 1	Height control switch (HEIGHT HIGH) / ON or OFF	ON: Switch is pressed and held OFF: Switch is not pressed	-

   OK

   On the Techstream screen, item changes between ON and OFF according to switch operation.

NG → See step   5 

OK → See step   9 

1. Turn the power switch OFF.
2. Connect the Techstream to the DLC3.
3. Turn the power switch ON (IG) and the Techstream ON.
4. Enter the following menus: Body Electrical / Center Console Switch / Data List.
5. Select each item below in the DATA LIST and read its value displayed on the Techstream screen.
   CENTER CONSOLE SWITCH
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   HEIGHT HIGH Switch	Height control switch (HEIGHT HIGH) / ON or OFF	ON: Switch is pressed and held OFF: Switch is not pressed	-
   SPORT Mode Switch	Absorber control switch (SPORT) / ON or OFF	ON: SPORT OFF: NORMAL	-
   COMFORT Mode Switch	Absorber control switch (COMFORT) / ON or OFF	ON: COMFORT OFF: NORMAL	-

   OK

   On the Techstream screen, item changes between ON and OFF according to switch operation.

NG → See step   11 

OK → See step   10