DTC C1789: Vehicle Identification Malfunction: Procedure

1. Check that vehicle identification information has been stored. Refer to INITIALIZATION .
   RESULT
   
   

   Result	Proceed to
   Information stored	A
   Information not stored	B

B → See step   5 

A: Go to next step 

1. Check that the part numbers of the installed hybrid vehicle control ECU and AFS ECU are correct.
   NOTE:

   When removing the hybrid vehicle control ECU and/or AFS ECU to check the part number, or when replacing the hybrid vehicle control ECU and/or AFS ECU, be sure to follow the appropriate procedures and precautions.

   HINT: 

   • Refer to the hybrid vehicle control ECU installation procedure. Refer to REMOVAL .
   • Refer to the AFS ECU installation procedure. Refer to REMOVAL .

   OK

   Hybrid vehicle control ECU and AFS ECU with correct part numbers are installed.

NG → REPLACE CORRESPONDING ECU 

OK: Go to next step 

1. Clear the DTCs. Refer to DTC CHECK / CLEAR .

NEXT: Go to next step 

1. Check if DTC C1789 is output. Refer to DTC CHECK / CLEAR .

   OK

   DTC C1789 is not output.

   HINT: 

   If no parts are replaced and DTC C1789 is output, there may be an internal malfunction in the suspension control ECU. In this case, replace the suspension control ECU.

NG → See step   7 

OK → See step   6