Inspection Procedure
NOTE:
- Before performing troubleshooting, inspect the connectors of related circuits.
- If DTC C1782 (Power Source Voltage Malfunction) is output at the same time, perform troubleshooting for C1782 first. Refer to DTC C1782: Power Source Voltage Malfunction .
- Before replacing the suspension control ECU, perform all of the following again: 1) symptom simulation. Refer to ELECTRONIC CIRCUIT INSPECTION PROCEDURE ; 2) DTC inspection; and 3) the Techstream inspection (Data List or Active Test). If no malfunctions are found in other areas, replace the suspension control ECU.
- If the suspension control ECU or height control sensor is replaced, the vehicle height offset calibration must be performed. Refer to INITIALIZATION .