LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2010 >> LS 460 AWD >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Audio / Visual (Service Information) >> Radio Receiver >> Removal >> Removal

Radio Receiver: Removal: Removal

  1. REMOVE COWL TOP VENTILATOR LOUVER RH  . Refer to REMOVAL - Step 1
  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    NOTE:
    • w/ Navigation System (for HDD):

      After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

      Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal

      Condition Waiting Time
      Vehicle enrolled in safety connect system 6 minutes
      Vehicle not enrolled in safety connect system 1 minute
    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .
  3. REMOVE INSTRUMENT PANEL FINISH PANEL END LH  . Refer to REMOVAL - Step 1
  4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH  . Refer to REMOVAL - Step 2
  5. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY  . Refer to REMOVAL - Step 3
  6. REMOVE NO. 3 BOX PANEL  . Refer to REMOVAL - Step 4
  7. REMOVE UPPER REAR CONSOLE PANEL SUB-ASSEMBLY  . Refer to REMOVAL - Step 5
  8. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY  . Refer to REMOVAL - Step 6
  9. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET 
    Fig 1: Remove the 2 bolts
    GTY253871Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Remove the 2 bolts.
    2. Pull the radio receiver to detach the 4 clips, 2 claws and 3 ribs on the backside of the radio receiver.
      Fig 2: Locating The 4 Clips, 2 Claws And 3 Ribs On The Backside Of The Radio Receiver
      GTY268093Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Disconnect the connectors and remove the radio receiver.
  10. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY 
    Fig 3: Identifying 2 Clips And 2 Claws
    GTY284180Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Detach the 2 clips and 2 claws and remove the panel
  11. REMOVE NO. 2 RADIO BRACKET 
    Fig 4: Locating 4 bolts and bracket
    GTY264114Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Remove the 4 bolts and bracket.
  12. REMOVE NO. 1 RADIO BRACKET 
    Fig 5: Locating 4 Bolts And Bracket
    GTY264380Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Remove the 4 bolts and bracket.
scientia non olet · About LEMON Manuals