Entire Combination Meter does not Operate: Procedure

1. Disconnect the J34 connector.
   Fig 1: Inspecting Combination Meter

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   J34-1 (E2) - Body ground	Always	Below 1 Ω
   J34-13 (ES) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   J34-12 (IG+) - Body ground	Engine switch on (IG)	11 to 14V
   J34-23 (B) - Body ground	Always	11 to 14 V
   J34-24 (B) - Body ground	Always	11 to 14 V

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → See step   2