Inspection Procedure: Notes
Perform the universal trip to clear permanent DTCs. Refer to DTC CHECK / CLEAR .
- DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
NOTE:In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
- Warm up the engine.
- Turn the engine switch off.
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG) position.
- Turn the Techstream on.
- Select the item "Powertrain / ECT / Data List".
- According to the display on the tester, read the "Data List".
Item Measurement Item/
Range (display)Normal Condition A/T Oil Temperature 1 ATF Temp. Sensor Value/
min.: -40°C (-40°F)
max.: 215°C (419°F)- After Stall Test;
Approx. 80°C (176°F)
- Equal to ambient temperature when cold soak
HINT:
When DTC P0712 is output and Techstream output is 150°C (302°F) or more, there is a short circuit.
When DTC P0713 is output and Techstream output is -40°C (-40°F), there is an open circuit.
Measure the resistance between terminal OIL and body ground.
Temperature Displayed Malfunction -40°C (-40°F) Open circuit 150 °C (302°F) or more Short circuit HINT:
If a circuit related to the ATF temperature sensor becomes open, P0713 is immediately set (in 0.5 second). When P0713 is set, P0711 cannot be detected.
It is not necessary to inspect the circuit when P0711 is set.
- After Stall Test;