LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2010 >> IS 350 >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Automatic Transmission (A760H) (Diagnostic Codes (P0500-U0100) & Circuit Tests)) >> Automatic Transmission System >> DTC P0711: Transmission Fluid Temperature Sensor "A" Performance >> Inspection Procedure >> Procedure

Inspection Procedure: Procedure

WARNING: This page is about a different car, the 2010 Lexus IS 250. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK OTHER DTCS OUTPUT (IN ADDITION TO DTC P0711) 
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG) position and push the Techstream main switch ON.
    3. When you use Techstream:

      Select the item "Powertrain / ECT / Trouble Codes".

    4. Read the DTCs using the Techstream.

      Result

      Display (DTC output) Proceed to
      Only "P0711" is output A
      "P0711" and other DTCs B

      HINT: 

      If any other codes besides "P0711" are output, perform troubleshooting for those DTCs first.

    B → GO TO DTC CHART 

    A: Go to next step 

  2. CHECK TRANSMISSION FLUID LEVEL 

    OK

    Automatic transmission fluid level is correct.

    NG → ADD FLUID 

    OK → REPLACE TRANSMISSION WIRE 

scientia non olet · About LEMON Manuals