Entire Combination Meter does not Operate: Procedure

1. Disconnect the J34 connector.
   Fig 1: Identifying J34 Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Measure the resistance according to the value(s) in the table below.

   Standard resistance

   Tester Connection	Condition	Specified Condition
   J34-1 (E2) - Body ground	Always	Below 1 Ω
   J34-13 (ES) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard voltage

   Tester Connection	Condition	Specified Condition
   J34-12 (IG+) - Body ground	Engine switch on (IG)	10 to 14V
   J34-23 (B) - Body ground	Always	10 to 14 V
   J34-24 (B) - Body ground	Always	10 to 14 V

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → REPLACE COMBINATION METER ASSEMBLY