LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2010 >> IS 250C Standard >> Repair and Diagnosis >> Body & Frame >> Sun Roof/T-Top/Convertible Top >> Retractable Hardtop (Diagnostic Codes (B2536-B256E) & Circuit Tests) >> Retractable Hardtop System >> DTC B2567: Quarter Window Switch LH Abnormal Operation >> Procedure

DTC B2567: Quarter Window Switch LH Abnormal Operation: Procedure

  1. READ VALUE USING TECHSTREAM (LH QUARTER WINDOW SW) 
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / Retractable Hardtop / Data List.
    5. Read the Data List according to the display on the Techstream.
      RETRACTABLE HARDTOP (SLIDING ROOF CONTROL ECU ASSEMBLY)

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      LH Quarter Window SW Quarter window limit switch LH signal/ON or OFF ON: Quarter window limit switch LH on (quarter window glass not fully closed)
      OFF: Quarter window limit switch LH off (quarter window glass fully closed)      		 -

      OK

      The Techstream display changes according to condition as shown in the table.

    NG → See step   2 

    OK → REPLACE SLIDING ROOF CONTROL ECU ASSEMBLY 

  2. CHECK POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (WINDOW REGULATOR LIMIT SWITCH) 
    1. Measure the resistance according to the value(s) in the table below.
      Fig 1: Identifying Power Window Regulator Motor Assembly RH (Window Regulator Limit Switch)
      GTY257477Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard Resistance

      Tester Connection Condition Specified Condition
      6 (LMT) - 5 (E) Quarter window glass LH not fully closed → fully closed Below 1 Ω → 10 kΩ or higher
      6 (LMT) - Body ground Always 10 kΩ or higher
      TEXT IN ILLUSTRATION

      *1 Component with harness connected
      (Power Window Regulator Motor Assembly LH)

    NG → REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (WINDOW REGULATOR LIMIT SWITCH) 

    OK: Go to next step 

  3. CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR MOTOR LH - SLIDING ROOF CONTROL ECU) 
    1. Disconnect the Q19 and Q36 connectors.
      Fig 2: Identifying Q19 & Q36 Connectors
      GTY258288Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      Q19-6 (LMT) - Q36-17 (QWL) Always Below 1 Ω
      Q19-5 (E) - Body ground Always Below 1 Ω
      Q19-6 (LMT) - Body ground Always 10 kΩ or higher
      TEXT IN ILLUSTRATION

      *1 Front view of wire harness connector
      (to Power Window Regulator Motor Assembly LH)
      *2 Front view of wire harness connector
      (to Sliding Roof Control ECU Assembly)

    NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK → REPLACE SLIDING ROOF CONTROL ECU ASSEMBLY 

scientia non olet · About LEMON Manuals