DTC B2565: Difference between RH and LH Luggage Door Drive Motor Pulse: Procedure

INSPECT LUGGAGE DOOR DRIVE GEAR ASSEMBLY RH (LUGGAGE MOTOR RH)

Remove the Luggage door drive gear assembly RH (luggage motor RH).

Fig 1: Identifying Luggage Door Drive Gear Assembly RH (Luggage Motor RH)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Apply battery voltage and check operation of the luggage motor.

Measurement Condition	Specified Condition
Battery positive (+) → 3 Battery negative (-) → 1	Motor gear rotates counterclockwise
Battery positive (+) → 1 Battery negative (-) → 3	Motor gear rotates clockwise

Connect an electrical tester DC 400 A probe to the wire harness of the motor.
NOTE:
Match the arrow mark of the probe with the direction of the current flow.

Measure the current according to the value(s) in the table below.

NOTE:

Make sure to perform the inspection after the motor cools down sufficiently. Otherwise the result may not meet the specified condition due to protection circuit operation in the motor.

Standard Current

Measurement Condition	Specified Condition
Battery positive (+) → 1 Battery negative (-) → 3	Below 5 A

TEXT IN ILLUSTRATION

*1	Component without harness connected (Luggage Door Drive Gear Assembly RH)
*2	Motor Gear
*3	Clockwise
*4	Counterclockwise

NG → REPLACE LUGGAGE DOOR DRIVE GEAR ASSEMBLY RH (LUGGAGE MOTOR RH)

OK: Go to next step

INSPECT LUGGAGE DOOR DRIVE GEAR ASSEMBLY LH (LUGGAGE MOTOR LH)

Remove the Luggage door drive gear assembly LH (luggage motor LH).

Fig 2: Identifying Luggage Door Drive Gear Assembly LH
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002