DTC B2558: Motor Lock in Luggage Door Drive Motor(RH): Procedure

1. Remove the luggage door drive gear assembly RH (luggage motor RH).
   Fig 1: Identifying Luggage Door Drive Gear Assembly RH (Luggage Motor RH)

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Apply battery voltage and check operation of the luggage motor.

   OK

   Measurement Condition	Specified Condition
   Battery positive (+) → Terminal 3 Battery negative (-) → Terminal 1	Motor gear rotates counterclockwise
   Battery positive (+) → Terminal 1 Battery negative (-) → Terminal 3	Motor gear rotates clockwise

3. Connect an electrical tester DC 400 A probe to the wire harness of the motor.
   NOTE:

   Match the arrow mark of the probe with the direction of the current flow.

4. Measure the current according to the value(s) in the table below.
   NOTE:

   Make sure to perform the inspection after the motor cools down sufficiently. Otherwise the result may not meet the specified condition due to protection circuit operation in the motor.

   Standard Current

   Measurement Condition	Specified Condition
   Battery positive (+) → Terminal 1 Battery negative (-) → Terminal 3	Below 5 A

   TEXT IN ILLUSTRATION
   
   

   *1	Component without harness connected (Luggage Door Drive Gear Assembly RH)
   *2	Motor Gear
   *3	Clockwise
   *4	Counterclockwise

NG → REPLACE LUGGAGE DOOR DRIVE GEAR ASSEMBLY RH (LUGGAGE MOTOR RH) 

OK → REPLACE SLIDING ROOF CONTROL ECU ASSEMBLY