Rear Brake Flexible Hose: Installation: Installation

NOTE:

Because the left and right hoses are not interchangeable, verify the part number when installing the flexible hoses.
If the hoses are to be reused, connect them after checking the identification marks placed when each hose was disconnected.

HINT:

Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.

INSTALL REAR FLEXIBLE HOSE
1. Install the rear flexible hose to the rear disc brake cylinder assembly with the union bolt and a new gasket.
  
  Fig 1: Identifying Rear Flexible Hose
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Torque: 30 N*m (310 kgf*cm, 22 ft.*lbf)
  
  NOTE:
  Install the flexible hose lock securely in the lock hole in the rear disc brake cylinder assembly.
2. Install a new clip to secure the rear flexible hose to the body bracket.
  TEXT IN ILLUSTRATION
  
  *1 Clip
  
  NOTE:
  Install the clip as far as it will go.
3. Using a union nut wrench, connect the brake line to the rear flexible hose.
  Torque: 15 N*m (155 kgf*cm, 11 ft.*lbf)
  NOTE:
  - Do not bend or damage the brake line.
  - Do not allow any foreign matter such as dirt and dust to enter the brake line.
  - Use the formula to calculate special torque values for situations where the union nut wrench is combined with a torque wrench. Refer to PRECAUTION .
BLEED BRAKE SYSTEM
HINT:
INSTALL REAR WHEEL
Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf)