Brake Line: Precaution: Precaution

NOTE:

Since the brake lines are classified as critical safety related parts, be sure to disassemble and inspect the components if a brake fluid leak is found. If any abnormality is found, replace the component with a new one.
When removing brake components, cover the brake line connections to prevent foreign matter such as dust or dirt from entering the lines.
Do not allow brake fluid to adhere to any painted surface such as the vehicle body. If brake fluid leaks onto any painted surface, immediately clean it off.
When installing a grommet to the body, ensure that the brake line passes through the center of the grommet.
Do not damage or deform the brake lines when removing and installing them.
When installing a brake line or flexible hose, ensure that they are free from twists or bends.
Do not deform the bracket and the body when connecting a brake line and flexible hose.
If the cap of a flexible hose does not match the groove on the bracket, twist the hose slightly to insert it.
Flexible hoses must be free from shock absorber oil, grease, etc.
When installing a brake line to a plastic clamp, ensure that the brake line is not loose or pinched.
Do not reuse any clips or plastic clamps removed from a flexible hose.
After installing a brake line or flexible hose, ensure that they do not interfere with any other components.

When disconnecting and connecting a flexible hose and brake line:

Fig 1: View Of Disconnecting/Connecting Flexible Hose And Brake Line

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

TEXT IN ILLUSTRATION

*1	Hold
*2	Turn

Hold the flexible hose with a wrench and disconnect the brake line with a union nut wrench without deforming the line.
Remove the clip.
Install a new clip.
Connect the brake line with a union nut wrench without deforming the line.

When connecting a brake line and way:

Fig 2: View Of Connecting A Brake Line

TEXT IN ILLUSTRATION

Support the way to prevent deformation of the brake line and connect the brake line to the way with a union nut wrench.
Support the way to prevent deformation of the brake line and install the bolt to secure the way to the body.