Valve Body Assembly: Removal: Removal

WARNING: This page is about a different variant/trim than selected.

REMOVE NO. 2 ENGINE UNDER COVER
DRAIN AUTOMATIC TRANSMISSION FLUID See step 2
REMOVE NO. 1 EXHAUST PIPE SUPPORT BRACKET SUB-ASSEMBLY See step 21
REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY See step 4
REMOVE VALVE BODY OIL STRAINER ASSEMBLY See step 5
DISCONNECT TRANSMISSION WIRE See step 6
REMOVE TRANSMISSION VALVE BODY ASSEMBLY
1. Remove the 19 bolts and valve body.
  
  Fig 1: Identifying Bolts And Valve Body
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Separate the lever pin from the manual valve.
  
  Fig 2: Aligning Groove Of Manual Valve With Pin Of Lever
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the check ball body and spring.
  NOTE:
  Do not drop the check ball body and spring.
  
  Fig 3: Identifying Check Ball Body And Spring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002