Valve Body Assembly: Installation: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL TRANSMISSION VALVE BODY ASSEMBLY
1. Install the check ball body and spring.
  
  Fig 1: Identifying Check Ball Body And Spring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Check the accumulator pistons, check ball body and spring as shown in the illustration.
  
  Fig 2: Identifying Accumulator Pistons, Check Ball Body And Spring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Align the groove of the manual valve with the pin of the lever.
  
  Fig 3: Aligning Groove Of Manual Valve With Pin Of Lever
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Install the 19 bolts.
  
  Fig 4: Identifying Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Torque: 11 N*m (112 kgf*cm, 8 ft.*lbf)
  
  Bolt length
  
  Bolt A
  
  25 mm (0.98 in.)
  
  Bolt B
  
  36 mm (1.42 in.)
  
  Bolt C
  
  45 mm (1.77 in.)
  
  Bolt D
  
  50 mm (1.97 in.)
CONNECT TRANSMISSION WIRE See step 2
INSTALL VALVE BODY OIL STRAINER ASSEMBLY See step 3
INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY See step 4
INSTALL NO. 1 EXHAUST PIPE SUPPORT BRACKET SUB-ASSEMBLY See step 11
ADD AUTOMATIC TRANSMISSION FLUID
INSTALL NO. 2 ENGINE UNDER COVER
RESET MEMORY