Oil Pump: Reassembly: Reassembly

WARNING: This page is about a different variant/trim than selected.

INSTALL FRONT OIL PUMP OIL SEAL
1. Using SST and a hammer, install a new oil seal.
  
  Fig 1: Identifying Front Oil Pump Oil Seal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  - SST: 09350-30020
    - 09351-32140
  HINT:
  
  The oil seal end should be flush with the outer edge of the pump body.
2. Coat the oil seal lip with MP grease.
FIX FRONT OIL PUMP BODY SUB-ASSEMBLY
1. Place the oil pump body on the torque converter clutch.
INSTALL FRONT OIL PUMP DRIVEN GEAR
1. Coat the driven gear with ATF.
  
  Fig 2: Identifying Front Oil Pump Driven Gear
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the driven gear to the oil pump body.
INSTALL FRONT OIL PUMP DRIVE GEAR
1. Coat the drive gear with ATF.
  
  Fig 3: Identifying Front Oil Pump Drive Gear
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the drive gear to the oil pump body.
INSTALL FRONT OIL PUMP BODY O-RING
1. Coat a new O-ring with ATF.
  
  Fig 4: Identifying Front Oil Pump Body O-Ring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the O-ring to the oil pump body.
INSTALL STATOR SHAFT ASSEMBLY
1. Align the stator shaft with each bolt hole.
  
  Fig 5: Identifying Stator Shaft Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the 14 hexagon bolts.
  Torque: 11 N*m (112 kgf*cm, 8 ft.*lbf)
INSTALL CLUTCH DRUM OIL SEAL RING
1. Coat 3 new oil seal rings with ATF.
  
  Fig 6: Identifying Oil Seal Rings
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Squeeze the ends of the 3 oil seal rings so that the gap distance becomes 8 mm or less, and then install them to the stator shaft groove.
  NOTE:
  Do not expand the ring ends excessively.
  
  HINT:
  
  After installing the oil seal rings, check that they rotate smoothly.
INSPECT OIL PUMP DRIVE GEAR ROTATION See step 4
INSTALL FRONT OIL PUMP BODY O-RING
1. Coat a new O-ring with ATF.
  
  Fig 7: Identifying Front Oil Pump Body O-Ring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the O-ring to the oil pump assembly.