LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2010 >> IS 250 AWD >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> Engine Mechanical (Service Information) >> Rear Crankshaft Oil Seal >> Installation >> Installation

Rear Crankshaft Oil Seal: Installation: Installation

  1. INSTALL ENGINE REAR OIL SEAL 
    1. Apply MP grease to the lip of a new oil seal.
      NOTE:

      Keep the lip free of foreign matter.

    2. Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.
      Fig 1: Installing Engine Rear Oil Seal
      GTY146240Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • SST: 09223-15030 
      • SST: 09950-70010 
        1. 09951-07150
      NOTE:
      • Wipe off extra grease of the crankshaft.
      • Keep the lip free of foreign matter.
      • Do not tap on the oil seal at an angle.
  2. INSTALL FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)  See step  31
  3. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transmission)  See step  32
  4. INSTALL MANUAL TRANSMISSION ASSEMBLY (for Manual Transmission) 

    HINT: 

    Refer to INSTALLATION .

  5. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission) 

    HINT: 

  6. INSPECT FOR OIL LEAK 
scientia non olet · About LEMON Manuals