Brake Pedal: Installation: Installation

1. Temporarily install the stop light switch assembly with the lock nut.
2. Fully tighten the stop light switch assembly with the lock nut after inspecting and adjusting brake pedal height. Refer to ADJUSTMENT .

1. Install the brake pedal support assembly with the bolt.
   Fig 1: Locating Brake Pedal Support Assembly Bolt

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Torque: 21 N*m (214 kgf*cm, 16 ft.*lbf) 

2. Engage the wire harness clamp.
   Fig 2: Connecting Connectors

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the 2 connectors.

HINT: 

Refer to the procedure from Install Brake Booster Assembly. Refer to INSTALLATION .