DTC P0C76-523: Hybrid Battery System Discharge Time Too Long: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
4. Check if DTCs are output.

   Result

   Result	Proceed to
   P0C76-523 only is output.	A
   Any of the following DTCs are also output.	B

   DTC No.	Relevant Diagnosis
   P0A1A-151, 155, 156, 200, 658, 659, 791, 792, 793	Generator Control Module
   P0A1B-163, 164, 168, 192, 193, 511, 512, 661, 786, 788, 794, 795, 796	Drive Motor "A" Control Module
   P0A3F-243	Drive Motor "A" Position Sensor Circuit
   P0A40-500	Drive Motor "A" Position Sensor Circuit Range/Performance
   P0A41-245	Drive Motor "A" Position Sensor Circuit Low
   P0A4B-253	Generator Position Sensor Circuit
   P0A4C-513	Generator Position Sensor Circuit Range/Performance
   P0A4D-255	Generator Position Sensor Circuit Low
   P0A78-266, 267	Drive Motor "A" Inverter Performance
   P0A94-442	DC / DC Converter Performance
   P0ADC-226	Hybrid Battery Positive Contactor Control Circuit High
   P0AE0-228	Hybrid Battery Negative Contactor Control Circuit High
   P0AE2-773, 161	Hybrid Battery Precharge Contactor Circuit Stuck Closed

   HINT: 

   P0C76-523 may be output due to a malfunction which causes the DTCs in the table above to be output. In this case, first troubleshoot the output DTCs in the table above. Then, perform a reproduction test to check that no DTCs are output.

5. Turn the power switch off.

B → See step   2 

A → See step   3