DTC P0C30-390: Hybrid Battery Pack State of Charge High: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
4. Read the freeze frame data of DTC P0C30-390.

   Result

   Result	Proceed to
   "WIN Control Power" is 0 W, and "SOC" is 70% or more.	A
   Other than above	B

5. Turn the power switch off.

B → See step   3 

A: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
4. Check if DTCs are output.

   Result

   Result	Proceed to
   P0C30-390 only is output.	A
   DTCs other than P0C30-390 are output.	B

5. Turn the power switch off.

B → See step   6 

A → See step   7 

1. Remove the hybrid vehicle control ECU. Refer toCOMPONENTS .

NEXT: Go to next step 

1. Remove the HV battery assembly. Refer toCOMPONENTS .

NEXT: Go to next step 

1. Remove the battery smart unit. Refer toCOMPONENTS .

NEXT → COMPLETED