Inner Rear View Mirror Power Source Circuit: Procedure

1. Disconnect the P9 inner rear view mirror assembly connector.
   Fig 1: Identifying P9 Inner Rear View Mirror Assembly Connector

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Switch Condition	Specified Condition
   P9-1 (IG) - P9-2 (E)	Power switch on (IG)	11 to 14 V
   	Power switch off	Below 1 V

   TEXT IN ILLUSTRATION
   
   

   *1	Front view of wire harness connector (to Inner Rear View Mirror Assembly)

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → See step   2