DTC C1792/92: Height Control Switch Circuit (Test Mode DTC): Procedure

1. Turn the engine switch off.
2. Connect the Techstream to the DLC3.
3. Turn the engine switch on (IG).
4. Turn the Techstream on.
5. Enter the following menus: Chassis / Air suspension / Data List.
   AIR SUSPENSION
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Height Control Switch (UP)	Height control switch ("up" side) / ON or OFF	ON: Switch is pressed and held OFF: Switch is not pressed	-
   Height Control Switch (DOWN)	Height control switch ("down" side) / ON or OFF	ON: Switch is pressed and held OFF: Switch is not pressed	-

6. Check that the value displayed on the Techstream changes by pressing the height control switch "up" side or "down" side.

   OK

   Height control switch value changes.

NG → See step   2 

OK → See step   4 

1. Turn the engine switch off.
2. Remove the combination switch. Refer to REMOVAL .
3. Measure the resistance according to the value(s) in the table below.
   Fig 1: Identifying Height Control Switch Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Standard Resistance

   Tester Connection	Switch Condition	Specified Condition
   14 (LO) - 9 (E)	"Down" pressed	Below 1 Ω
   14 (LO) - 9 (E)	"Up" pressed	10 kΩ or higher
   7 (HI) - 9 (E)	"Down" pressed	10 kΩ or higher
   7 (HI) - 9 (E)	"Up" pressed	Below 1 Ω

   TEXT IN ILLUSTRATION
   
   

   *a	Component without harness connected (Height Control Switch [Combination Switch])

NG → See step   5 

OK: Go to next step 

1. Disconnect the i5 combination switch connector.
2. Disconnect the A40 suspension control ECU connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   I5-7 (HI) - A40-15 (UPSW)	Always	Below 1 Ω
   I5-14 (LO) - A40-14 (DNSW)	Always	Below 1 Ω
   i5-9 (E) - Body ground	Always	Below 1 Ω
   i5-7 (HI) - Body ground	Always	10 kΩ or higher
   i5-14 (LO) - Body ground	Always	10 kΩ or higher

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → See step   6