Absorber Control Indicator Light Remains ON: Procedure

1. Check DTC. Refer to DTC CHECK / CLEAR .

   Result

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

B → REPAIR CIRCUIT INDICATED BY OUTPUT CODE 

A: Go to next step 

1. Perform test mode. Refer to TEST MODE PROCEDURE .
2. Check if the test mode DTC C1787/87 is output.

   Result

   Result	Proceed to
   DTC C1787/87 is not output	A
   DTC C1787/87 is output	B

B → REPAIR CIRCUIT INDICATED BY OUTPUT CODE 

A: Go to next step 

1. Check if the CAN communication system DTC is output. Refer to DTC CHECK / CLEAR .

   Result

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

B → REPAIR CIRCUIT INDICATED BY OUTPUT CODE 

A: Go to next step 

1. Check if the multiplex communication system DTC is output. Refer to DTC CHECK / CLEAR .

   Result

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

B → REPAIR CIRCUIT INDICATED BY OUTPUT CODE 

A: Go to next step 

1. Check the combination meter assembly. Refer to HOW TO PROCEED WITH TROUBLESHOOTING .

   OK

   The combination meter assembly is normal.

   Result

   Result	Proceed to
   OK	A
   OK (when troubleshooting accordance with the PROBLEM SYMPTOMS TABLE)	B
   NG	C

C → REPLACE COMBINATION METER ASSEMBLY 

B → PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN  PROBLEM SYMPTOMS TABLE 

A → REPLACE ABSORBER CONTROL ECU