LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2010 >> GS 450h >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Luggage Compartment Door Opener (Diagnostics) >> Luggage Compartment Door Opener System >> Luggage Compartment Door Open Switch Circuit >> Procedure

Luggage Compartment Door Open Switch Circuit: Procedure

  1. INSPECT LUGGAGE COMPARTMENT DOOR STRIKER (DOOR UNLOCK SWITCH) 
    Fig 1: Disconnecting X2 Striker Connector
    GTY101227Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Disconnect the X2 striker connector.
    2. Measure the resistance of the striker.

      Standard resistance

      Tester Connection Condition Specified Condition
      1 - 2 Pushed Below 1 Ω
      1 - 2 Not pushed 10 kΩ or higher

    NG → REPLACE LUGGAGE COMPARTMENT DOOR STRIKER 

    OK: Go to next step 

  2. CHECK WIRE HARNESS (LUGGAGE COMPARTMENT DOOR STRIKER - MAIN BODY ECU LH AND BODY GROUND) 
    Fig 2: Identifying X2 And V3 Connector Terminals
    GTY131436Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Disconnect the X2 striker connector.
    2. Disconnect the V3 ECU connector.
    3. Measure the resistance of the wire harness side connectors.

      Standard resistance

      Tester Connection Specified Condition
      X2-1 - V3-11 (BDCY) Below 1 Ω
      X2-2 - Body ground Below 1 Ω
      X2-1 - Body ground 10 kΩ or higher

    NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK → PROCEED TO NEXT CIRCUIT INSPECTION SHOWN ON  PROBLEM SYMPTOMS TABLE  PROBLEM SYMPTOMS TABLE 

scientia non olet · About LEMON Manuals