DTC C1419: Acceleration Sensor Internal Circuit; DTC C1435: Yaw Rate Sensor Internal Circuit: Procedure
WARNING: This page is about a different car, the 2009 Lexus IS 350 and 2009 Lexus IS 250. However, it is still accessible from the selected car via links, so may be relevant.
- REPLACE YAW RATE AND ACCELERATION SENSOR
- Replace the yaw rate and acceleration sensor. Refer to REMOVAL
.NOTE:
Check the yaw rate and acceleration sensor signal after replacement. Refer to TEST MODE PROCEDURE .
HINT:
If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step. Refer to PROBLEM SYMPTOMS TABLE .
NEXT → END
- Replace the yaw rate and acceleration sensor. Refer to REMOVAL
.