LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2010 >> GS 350 AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 197 (Can Communication (Diagnostics)) >> Can Communication System >> Gateway ECU Communication Stop Mode >> Procedure

Gateway ECU Communication Stop Mode: Procedure

WARNING: This page is about a different car, the 2009 Lexus IS 350 and 2009 Lexus IS 250. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK WIRE HARNESS (BATT, ACC, IG, GND) 
    1. Turn the engine switch off.
    2. Disconnect the gateway ECU connector.
    3. Measure the resistance according to the value(s) in the table below.
      Fig 1: Identifying Gateway ECU Connector
      GTY132576Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard Resistance

      Tester Connection Condition Specified Condition
      J76-24 (GND) - Body ground Always Below 1 Ω
    4. Measure the voltage according to the value(s) in the table below.

      Standard Voltage

      Tester Connection Condition Specified Condition
      J76-10 (BATT) - Body ground Always 11 to 14 V
      J76-2 (ACC) - Body ground Engine switch on (IG) 11 to 14 V
      J76-1 (IG) - Body ground Engine switch on (IG) 11 to 14 V

    NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK → REPLACE GATEWAY ECU 

scientia non olet · About LEMON Manuals