LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2010 >> GS 350 AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 157 (Engine Control System (2GR-FSE) (Service Information)) >> Crankshaft Position Sensor >> Installation >> Installation

Crankshaft Position Sensor: Installation: Installation

WARNING: This page is about a different car, the 2009 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL CRANKSHAFT POSITION SENSOR 
    1. Apply a coat of engine oil to an O-ring of the crankshaft position sensor.
    2. Install the crankshaft position sensor with the bolt.
      Fig 1: Identifying Crankshaft Position Sensor
      GTY102959Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 10 N*m ( 102 kgf*cm, 7 ft.*lbf) 

    3. Connect the crankshaft position sensor connector.
  2. INSTALL COMPRESSOR WITH PULLEY ASSEMBLY  . Refer to INSTALLATION - Step 1
  3. INSTALL DISCHARGE HOSE SUB-ASSEMBLY  . Refer to INSTALLATION - Step 2
  4. INSTALL NO. 1 COOLER REFRIGERANT SUCTION HOSE  . Refer to INSTALLATION - Step 3
  5. INSTALL V-RIBBED BELT  . Refer to INSTALLATION - Step 1
  6. INSTALL REAR ENGINE UNDER COVER LH 
  7. INSTALL ENGINE UNDER COVER 
  8. INSTALL NO. 1 INLET AIR CLEANER  . Refer to INSTALLATION - Step 61
  9. INSTALL V-BANK COVER SUB-ASSEMBLY  . Refer to INSTALLATION - Step 86
  10. CHARGE REFRIGERANT  . Refer to REPLACEMENT - Step 2
  11. WARM UP ENGINE  . Refer to REPLACEMENT - Step 3
  12. CHECK FOR LEAKAGE OF REFRIGERANT  . Refer to REPLACEMENT - Step 4
  13. REMOVE COOL AIR INTAKE DUCT SEAL  . Refer to INSTALLATION - Step 89
scientia non olet · About LEMON Manuals