FRONT SHOCK ABSORBER (for 2WD): Disposal: Disposal

WARNING: This page is about a different car, the 2009 Lexus IS 350 and 2009 Lexus IS 250. However, it is still accessible from the selected car via links, so may be relevant.

DISPOSE OF FRONT SHOCK ABSORBER
1. Fully extend the front shock absorber rod.
  
  Fig 1: Identifying Front Shock Absorber Disposal Procedure
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using a drill, make a hole in the cylinder between A and B as shown in the illustration to discharge the gas inside.
  NOTE:
  Be careful when drilling because shards of metal may fly about, so always use proper safety equipment.
  
  HINT:
  
  The gas is colorless, odorless and non-poisonous.