Steering Pad Switch: Installation: Installation

INSTALL STEERING PAD SWITCH ASSEMBLY
1. Engage the 4 claws.
  
  Fig 1: Identifying Steering Pad Switch, Screws And Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the steering pad switch assembly with the 2 screws.
  Torque: 2.4 N*m (25 kgf*cm, 21 in.*lbf)
3. Connect the connector to the spiral cable.
INSTALL STEERING PAD . Refer to INSTALLATION - Step 1
INSTALL LOWER NO. 3 STEERING WHEEL COVER . Refer to INSTALLATION - Step 2
INSTALL LOWER NO. 2 STEERING WHEEL COVER . Refer to INSTALLATION - Step 3
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
INSPECT SRS WARNING LIGHT . Refer to INSTALLATION - Step 7
PERFORM INITIALIZATION
NOTE:
Some systems need initialization after reconnecting the cable to the negative battery terminal. Refer to INITIALIZATION .