Height Control OFF Indicator Light Circuit: Procedure

1. Remove the combination meter.
   Fig 1: Identifying Combination Meter Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Check indicator light on the combination meter assembly.
   1. Check that the height control OFF indicator light comes on when battery positive voltage is applied to the terminals as shown in the chart below.

      Indicator Light	Battery Positive	Battery Negative
      OFF	C8-16	C8-9

      OK

      Height control OFF indicator light comes on.

NG → REPLACE COMBINATION METER ASSEMBLY 

OK: Go to next step 

1. Disconnect the suspension control ECU S16 connector.
   Fig 2: Identifying Suspension Control ECU S16 Connector

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Measure the resistance according to the values in the table below.

   Standard resistance

   Tester Connection	Specified Condition
   S16-15 (OFID) - C8-9	Below 1 Ω
   S16-15 (OFID) - Body ground	10 kΩ or higher

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → REPLACE PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN  PROBLEM SYMPTOMS TABLE