Inspection Procedure
NOTE:
- DTC P3246-202 is stored after any of DTCs P0A78-113, 128, 284, 286, 287, 505, 506, 806, 807 and 808 are stored. After troubleshooting and repairing DTC P3246-202, be sure to troubleshoot all the other DTCs.
- The monitor cable and hybrid vehicle transmission assembly may be affected depending on the vehicle operating conditions if a short occurs in the inverter with converter assembly. If DTC P3246-202 is output, inspect the motor cable and hybrid vehicle transmission assembly and replace the defective parts.
- After completing the repair, test-drive the vehicle at a speed of approximately 25 mph (40 km/h) for 1 minute and check that DTC P0A90-251 (Driver Motor "A" Performance) is not output. If DTC P0A90-251 (Driver Motor "A" Performance) is output, replace the hybrid vehicle transmission assembly.