DTC P0A92-261: Hybrid Generator Performance: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Select the following menu items: Powertrain / Hybrid Control / Trouble Codes.
4. Check if DTCs are output.

   Result

   Result	Proceed to
   P0A92-261 only is output.	A
   Any of the following DTCs are also output.	B

   DTC No.	Relevant Diagnosis
   P0A1A (all INF codes) *1	Generator Control Module
   P0A1B (all INF codes) *1	Drive Motor "A" Control Module
   P0A1D (all INF codes) *1	Hybrid Powertrain Control Module
   P0A3F-243	Drive Motor "A" Position Sensor Circuit
   P0A40-500	Drive Motor "A" Position Sensor Circuit Range / Performance
   P0A41-245	Drive Motor "A" Position Sensor Circuit Low
   P0A4B-253	Generator Position Sensor Circuit
   P0A4C-513	Generator Position Sensor Circuit Range / Performance
   P0A4D-255	Generator Position Sensor Circuit Low
   P0A60 (all INF codes) *1	Drive Motor "A" Phase V Current
   P0A63 (all INF codes) *1	Drive Motor "A" Phase W Current
   P0A72 (all INF codes) *1	Generator Phase V Current
   P0A75 (all INF codes) *1	Generator Phase W Current
   P0A78-266, 267, 306, 586, 523	Drive Motor "A" Inverter Performance
   P0A7A-344	Generator Inverter Performance
   P0A90-509	Drive Motor "A" Performance
   P0A92-521	Hybrid Generator Performance
   P0A94-585, 587, 589, 590	DC / DC Converter Performance
   P0AA6 (all INF codes) *1	Hybrid Battery Voltage System Isolation Fault
   P3004-132	Power Cable Malfunction
   P3233-750	Short to B+ in Blocking of HV Gate Connection

   HINT: 

   • *1: If any INF codes are output for this DTC, refer to the corresponding diagnostic flowchart.
   • P0A92-261 may be set due to a malfunction which also causes DTCs in the preceding table to be set. In this case, first troubleshoot the output DTCs in the preceding table. Then, perform a test to attempt to reproduce the problems, and check that no DTCs are output.

B → See step   6 

A: Go to next step 

1. Leave the vehicle for 1 minute with the engine on (with MG1 rotating).

   HINT: 

   If the accelerator pedal is depressed with the shift lever in the P position, the engine will start.

2. Select the following menu items: Powertrain / Hybrid Control / Trouble Codes.
3. Check if DTCs are output.

   Result

   Result	Proceed to
   P0A92-261 is output or no DTC is output.	A
   P0A7A-344 or P0A92-521 is output.	B

B → See step   6 

A: Go to next step 

NG → CONNECT SECURELY 

OK: Go to next step 

C → CONNECT SECURELY 

B → REPLACE MALFUNCTIONING PARTS 

A: Go to next step 

C → CONNECT SECURELY 

B → REPLACE MALFUNCTIONING PARTS 

A → See step   7