Hybrid System Indicator Malfunction: Procedure
- CHECK CAN COMMUNICATION SYSTEM
- Check for the DTC. Refer to DTC CHECK / CLEAR
.RESULT:
Result Proceed to DTC is not output A CAN communication system DTC is output B Hybrid control system DTC is output C
C → See step 5
B → See step 4
A: Go to next step
- Check for the DTC. Refer to DTC CHECK / CLEAR
.
- PERFORM ACTIVE TEST USING TECHSTREAM (POWER METER)
- Operate the Techstream according to the display and select "Active Test".COMBINATION METER:
Tester Display Test Part Control Range Diagnostic Note Hybrid system indicator Hybrid system indicator 300, 250, 150, 100, 50, 0 or MAX Perform test with the vehicle stopped and engine idling OK
Needle indication is normal.
NG → See step 6
OK → See step 3
- Operate the Techstream according to the display and select "Active Test".
- Go to HYBRID CONTROL SYSTEM. Refer to PROBLEM SYMPTOMS TABLE
- Go to CAN COMMUNICATION SYSTEM. Refer to CAN COMMUNICATION SYSTEM
- Go to HYBRID CONTROL SYSTEM. Refer to DIAGNOSTIC TROUBLE CODE CHART
- REPLACE No. 1 METER ECU. Refer to DISASSEMBLY