Installation

AXLE AND DIFFERENTIAL: REAR AXLE CARRIER: INSTALLATION

INSTALLATION
HINT:
- Use the same procedure for the RH side and LH side.
- The procedure listed below is for the LH side.

1. INSTALL REAR AXLE CARRIER SUB-ASSEMBLY
(a) Hold the rear axle carrier sub-assembly between aluminium plates in a vise.
NOTE:
Do not overtighten the vise.





(b) Install the parking brake anchor block, cable support bracket and parking brake plate with the 2 nuts.
Torque: 76 Nm (775 kgf-cm, 56 ft-lbf)
2. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY Installation
3. INSTALL REAR NO. 2 WHEEL BEARING DUST DEFLECTOR Installation
4. INSTALL REAR AXLE ASSEMBLY
HINT: Refer to the procedure from Install Rear Axle Assembly Installation.