Seat Position Sensor: Testing and Inspection

SUPPLEMENTAL RESTRAINT SYSTEMS: SEAT POSITION SENSOR: ON-VEHICLE INSPECTION

ON-VEHICLE INSPECTION

1. INSPECT SEAT POSITION SENSOR (VEHICLE NOT INVOLVED IN COLLISION)
(a) Perform a diagnostic system check DTC Check / Clear.
2. INSPECT SEAT POSITION SENSOR (VEHICLE INVOLVED IN COLLISION)
(a) Perform a diagnostic system check DTC Check / Clear.
(b) Even if an airbag was not deployed, check if there is any damage to the seat position sensor.
If there are any following defects, replace the seat position sensor with a new one:
- Cracks, dents or chips on the sensor housing.
- Cracks or other damage to the connector.
CAUTION:
Be sure to follow the correct removal and installation procedures of the seat position sensor.