Removal

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: YAW RATE AND ACCELERATION SENSOR: REMOVAL

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY Removal
3. REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH Removal
4. REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH Removal
5. REMOVE CONSOLE PANEL SUB-ASSEMBLY Removal
6. REMOVE FRONT ASH RECEPTACLE ASSEMBLY Removal
7. REMOVE REAR ASH RECEPTACLE ASSEMBLY Removal
8. REMOVE CONSOLE BOX REGISTER ASSEMBLY Removal
9. REMOVE CONSOLE BOX Removal
10. REMOVE NO. 2 CONSOLE BOX DUCT Removal
11. REMOVE YAW RATE AND ACCELERATION SENSOR





(a) Separate the 2 wire harness clamps.
(b) Remove the 2 bolts and yaw rate and acceleration sensor.





(c) Disconnect the yaw rate and acceleration sensor connector.
NOTE:
Do not remove the sensor from the bracket.