Removal

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: REAR SPEED SENSOR: REMOVAL

REMOVAL
HINT:
- Use the same procedure for the RH side and LH side.
- The procedure listed below is for the LH side.
- If the sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly.

1. REMOVE REAR WHEEL
2. REMOVE REAR SPEED SENSOR WIRE





(a) Using a screwdriver, disconnect the rear speed sensor wire.
3. REMOVE REAR SPEED SENSOR





(a) Remove the bolt and rear speed sensor.
NOTE:
Prevent foreign matter from attaching to the sensor tip.