Front Passenger Airbag Assembly: Installation: Installation

INSTALL FRONT PASSENGER AIRBAG ASSEMBLY
1. Connect the 2 connectors and the 2 clamps to the front passenger airbag assembly.
  
  Fig 1: Identifying Connectors And Clamps
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  NOTE:
  When handling the airbag connector, take care not to damage the airbag wire harness.
2. Engage the 5 hooks (A).
  
  Fig 2: Identifying Hooks
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Engage the 5 hooks (B) and install the front passenger airbag assembly on the instrument panel.
4. Install the 2 screws.
  
  Fig 3: Identifying Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL SIDE DEFROSTER NOZZLE NO. 2 DUCT . Refer to REASSEMBLY - Step 15
INSTALL HEATER TO REGISTER NO. 3 DUCT . Refer to REASSEMBLY - Step 17
INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
HINT:

Refer to the procedures from "INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY". Refer to INSTALLATION .
CONNECT INSTRUMENT PANEL WIRE ASSEMBLY
1. Connect the connector.
  
  Fig 4: Identifying Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY . Refer to INSTALLATION - Step 14
INSTALL FRONT PASSENGER AIRBAG ASSEMBLY See step 1
INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY . Refer to INSTALLATION - Step 16
INSTALL INSTRUMENT SIDE PANEL RH . Refer to INSTALLATION - Step 17
INSTALL FRONT DOOR OPENING TRIM COVER RH . Refer to INSTALLATION - Step 18
INSTALL FRONT DOOR SCUFF PLATE (w/ Illumination)
INSTALL FRONT DOOR SCUFF PLATE (w/o Illumination)
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
INSPECT SRS WARNING LIGHT
1. Inspect the SRS warning light. Refer to DIAGNOSIS SYSTEM .