LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2009 >> IS 250 RWD, Automatic >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter (Service Information) >> Steering Pad Switch >> Removal >> Removal

Steering Pad Switch: Removal: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    WARNING:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

  2. REMOVE NO. 3 LOWER STEERING WHEEL COVER  . Refer to REMOVAL - Step 3
  3. REMOVE NO. 2 LOWER STEERING WHEEL COVER  . Refer to REMOVAL - Step 4
  4. REMOVE STEERING PAD  . Refer to REMOVAL - Step 5
  5. REMOVE STEERING PAD SWITCH ASSEMBLY 
    1. Disconnect the 2 connectors and disengage the clamp.
      Fig 1: Identifying Connectors And Clamp
      GTY130886Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 screws.
      Fig 2: Identifying Steering Pad Switch Assembly Pins
      GTY151045Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Disengage the 4 pins and remove the steering pad switch assembly.