Fuel Receiver Gauge Malfunction: Procedure

1. Remove the fuel sender gauge assembly.
2. Check that the float position is between E and F.
   Fig 1: Identifying Fuel Sender Gauge Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Measure the resistance between terminals 2 and 3 of the connector according to the value(s) in the table below.

   Standard resistance

   Float level	Float position mm (in.)	Resistance (Ω)
   F	88.6 (3.49) +- 3 (0.12)	4.0 +- 1
   1/2	6.4 (0.25)	59
   E	102.9 (4.05) +- 3 (0.12)	110.0 +- 2.5

NG → REPLACE FUEL SENDER GAUGE ASSEMBLY 

OK: Go to next step 

1. Disconnect the C9, C11and F5 connectors.
2. Measure the resistance according to the value(s) in the table below.

   Standard resistance

   Tester connection	Condition	Specified condition
   C11-4 (FUEL (FR)) - F15-2	Always	Below 1 Ω
   C9-10 (FUEL GND) - F15-3	Always	Below 1 Ω

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → REPLACE COMBINATION METER ASSEMBLY