DTC P3232-749: Short to GND in Blocking of HV Gate Connection: Procedure

1. Turn the power switch off and remove the service plug grip. Refer to PRECAUTION .
   Fig 1: Identifying A54 And A60 Connectors Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   NOTE:

   After removing the service plug grip, do not turn the power switch on (READY), unless instructed by the repair service information because this may cause a malfunction.

2. Disconnect connector A54 from the hybrid vehicle control ECU.
3. Disconnect connector A60 from the inverter with converter assembly.
4. Measure the resistance according to the value(s) in the table below.

   Standard resistance

   Tester Connection	Specified Condition
   HSDN (A54-73) - HSDN (A60-6)	10 kΩ or more

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to next step 

1. Measure the resistance according to the value(s) in the table below.
   Fig 2: Identifying A60 Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Standard resistance

   Tester Connection	Specified Condition
   HSDN (A60-6) - Body ground	2.65 to 3.55 kΩ

NG → REPLACE INVERTER WITH CONVERTER ASSEMBLY 

OK → See step   3