Odo/Trip Switch Malfunction: Procedure

1. Check the DTC . Refer to DIAGNOSTIC TROUBLE CODE CHART .
   RESULT:
   
   

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

B → See step   3 

A: Go to next step 

1. Connect the Techstream to the DLC3.
2. Power switch on (IG).
3. Turn the tester ON.
4. Enter following menus: Body Electrical / D-SEAT SW / Data List.
5. Check the values by referring to the table below.
   D-SEAT SW:
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   ODO/TRIP Change SW	ODO/TRIP change switch condition	ON: ODO/TRIP change switch is pushed OFF: ODO/TRIP change switch is not pressed	-
   Trip Reset Sw	Trip Reset switch condition	ON: ODO/TRIP change switch is pushed OFF: ODO/TRIP change switch is not pressed	-

   OK

   Switch condition (ON/OFF) can be switched by actual operation.

NG → REPLACE INTEGRATION CONTROL AND PANEL 

OK → REPLACE COMBINATION METER