Combination Meter: Removal: Removal

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Refer to INITIALIZATION .
REMOVE UPPER STEERING COLUMN COVER
for 2GR-FSE:. Refer to REMOVAL - Step 17

for 1UR-FSE:. Refer to REMOVAL - Step 17
REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
1. Using a screwdriver, disengage the 5 clips.
  
  Fig 1: Identifying Cluster Finish Panel
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  HINT:
  
  Tape the screwdriver tip before use.
2. Remove the instrument cluster finish panel sub-assembly and then disconnect the connector.
REMOVE COMBINATION METER ASSEMBLY
1. Remove the 4 screws.
  
  Fig 2: Locating Combination Meter Mounting Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the connector and remove the combination meter assembly.
REMOVE COMBINATION METER GLASS
1. Using a screwdriver, disengage the 2 claws and open the cover.
  
  Fig 3: Opening Cover And Detaching Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  HINT:
  
  Tape the screwdriver tip before use.
2. Disconnect the 3 connectors.
  
  Fig 4: Locating Combination Meter Connectors
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Disengage the 7 claws and remove the glass.
  
  Fig 5: Identifying Glass Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002