Combination Meter: Installation: Installation

INSTALL COMBINATION METER GLASS
1. Install the glass and engage the 7 claws.
  
  Fig 1: Identifying Glass Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the combination meter glass's wire harness with the clamps.
  
  Fig 2: Identifying Combination Meter Glass Wire Harness With Clamps
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the 3 connectors.
  
  Fig 3: Locating Combination Meter Connectors
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Close the cover.
  
  Fig 4: Closing Cover And Attaching Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Engage the 2 claws.
INSTALL COMBINATION METER ASSEMBLY
1. Connect the connector.
  
  Fig 5: Locating Combination Meter Mounting Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the combination meter assembly with the 4 screws.
INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
1. Connect the connector.
  
  Fig 6: Connecting Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Engage the 5 clips to install the instrument cluster finish panel sub-assembly.
INSTALL UPPER STEERING COLUMN COVER
for 2GR-FSE:. Refer to INSTALLATION - Step 9

for 1UR-FSE. Refer to INSTALLATION - Step 10
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Refer to INITIALIZATION .