Odo/TRIP SWITCH MALFUNCTION: Procedure

Please follow the information. Refer to HOW TO PROCEED WITH TROUBLESHOOTING .

If the multiplex communication system is operating normally, proceed to the next step.

Next: Go to next step 

1. Connect the Techstream to the DLC3.
2. Ignition switch on (IG).
3. Turn the tester ON.
4. Enter following menus: Body Electrical / D-SEAT SW / Data List.
5. Check the values by referring to the table below.
   D-SEAT SW:
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   ODO/TRIP Change SW	ODO/TRIP change switch condition	ON: ODO/TRIP change switch is pushed OFF: ODO/TRIP change switch is not pressed	-
   Trip Reset Sw	Trip Reset switch condition	ON: ODO/TRIP change switch is pushed OFF: ODO/TRIP change switch is not pressed	-

   OK

   Switch condition (ON/OFF) can be switched by actual operation.

NG → REPLACE INTEGRATION CONTROL AND PANEL ASSEMBLY 

OK → REPLACE COMBINATION METER