Speedometer Malfunction: Procedure

1. Check if CAN communication DTC is output . Refer to DIAGNOSIS SYSTEM .

   Result

   Result	Proceed to
   CAN communication DTC is not output.	A
   CAN communication DTC is output.	B . Refer to DIAGNOSTIC TROUBLE CODE CHART

B → GO TO CAN COMMUNICATION SYSTEM 

A: Go to next step 

1. Connect Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the tester ON.
4. Enter the following menus: Body Electrical / Combination Meter / Active Test.
5. Check the operation by referring to the table below.
   COMBINATION METER:
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Speed Meter Operation	Speedometer	0, 40, 80, 120 mph (*1)	-
   		0, 40, 80, 120, 160, 200, 240 km/h (*2)

   *1: for U.S.A.

   *2: except for U.S.A.

   OK

   Needle indication is normal.

NG → REPLACE COMBINATION METER ASSEMBLY 

OK: Go to next step 

1. Connect Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the tester ON.
4. Enter the following menus: Body Electrical / Combination Meter / Data List.
5. Check the values by referring to the values in the table below.
   COMBINATION METER:
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Vehicle Speed Meter	Vehicle speed/Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph)	Almost same as actual speed (When driving)	-

   OK

   Vehicle speed displayed on the tester is almost the same as the actual vehicle speed measured using a speedometer tester (calibrated chassis dynamometer).

NG → See step   4 

OK → REPLACE COMBINATION METER ASSEMBLY 

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the tester ON.
4. Enter the following menus: Chassis / ABS/VSC/TRAC / Data List.
5. Check the values by referring to the table below.
   ABS/VSC/TRAC:
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   FR/FL/RR/RL Wheel Speed	Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)	Almost same as actual speed (When driving)	-

   OK

   Vehicle speed displayed on the tester is almost the same as the actual vehicle speed measured using a speedometer tester (calibrated chassis dynamometer).

NG → GO TO BRAKE CONTROL SYSTEM 

OK: Go to next step 

1. Replace the skid control ECU with a new or a normal one.

   OK

   The operation of the speedometer returns to normal.

NG → REPLACE COMBINATION METER ASSEMBLY 

OK → END