Entire Combination Meter does not Operate: Procedure

1. Disconnect the E19 connector.
   Fig 1: Identifying Combination Meter E19 Connector Terminal

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Measure the resistance according to the value(s) in the table below.

   Standard resistance

   Tester Connection	Condition	Specified Condition
   E19-12 (E2) - Body ground	Always	Below 1 Ω
   E19-24 (ES) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard voltage

   Tester Connection	Condition	Specified Condition
   E19-13 (IG+) - Body ground	Turn the engine switch on (IG)	10 to 14 V
   E19-1 (B2) - Body ground	Always	10 to 14 V
   E19-2 (B) - Body ground	Always	10 to 14 V

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → REPLACE COMBINATION METER ASSEMBLY