LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> RX 400h FWD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System >> Spiral Cable >> Removal

Spiral Cable: Removal

  1. PRECAUTION 
    CAUTION: Be sure to read the "PRECAUTION" thoroughly before servicing (See PRECAUTION  ).
  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working
  3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD 
  4. REMOVE STEERING WHEEL NO.3 COVER LOWER  (See REMOVAL  )
  5. REMOVE STEERING WHEEL NO.2 COVER LOWER  (See REMOVAL  )
  6. REMOVE STEERING PAD  (See REMOVAL  )
  7. REMOVE STEERING WHEEL ASSEMBLY (for Manual Tilt)  (See REMOVAL )
  8. REMOVE STEERING WHEEL ASSEMBLY (for Power Tilt and Power Telescopic)  (See REMOVAL )
  9. REMOVE STEERING COLUMN COVER (for Manual Tilt)  (See REMOVAL )
  10. REMOVE STEERING COLUMN COVER (for Power Tilt and Power Telescopic)  (See REMOVAL )
  11. REMOVE SPIRAL CABLE 
    1. Disconnect the connectors from the spiral cable.
      NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
    2. Disengage the 3 claws and remove the spiral cable.
      3. Fig 1: Identifying Claws And Spiral Cable
      G05270350Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  12. REMOVE STEERING ANGLE SENSOR  (See REMOVAL )
scientia non olet · About LEMON Manuals