LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> RX 400h FWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brake System (Service Information) >> Rear Brake Pad, Brake Caliper & Brake Rotor >> Removal

Rear Brake Pad, Brake Caliper & Brake Rotor: Removal

  1. REMOVE REAR WHEEL 
  2. DRAIN BRAKE FLUID 
  3. DISCONNECT REAR FLEXIBLE HOSE 
    1. Remove the union bolt and the gasket from the rear disc brake cylinder assembly, then disconnect the flexible hose.
  4. REMOVE REAR DISC BRAKE CYLINDER SLIDE PIN NO.2 
    1. Remove the rear disc brake cylinder slide pin No.2.
  5. REMOVE REAR DISC BRAKE CYLINDER SLIDE PIN NO.1 
    1. Remove the rear disc brake cylinder slide pin No.1.
    Fig 1: Locating Brake Cylinder Caliper Bolt
    G05202935Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY 
    1. Remove the rear disc brake cylinder assembly.
scientia non olet · About LEMON Manuals