Front Brake Pad, Brake Caliper & Brake Rotor: Installation

1. INSTALL DISC BRAKE CYLINDER ASSEMBLY 
   1. Install the disc brake cylinder assembly with the 2 bolts.

      Torque: 34 N*m (350 kgf*cm, 25 ft.*lbf) 

   2. Connect the flexible hose with the union bolt and a new gasket.

   Torque: 29 N*m (300 kgf*cm, 21 ft.*lbf) 

   Fig 1: Installing Disc Brake Cylinder Assembly With Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. ADD RESERVOIR WITH BRAKE FLUID  (See BLEEDING )
3. DISABLE BRAKE CONTROL  (See BLEEDING )
4. BLEED FRONT BRAKE SYSTEM  (See BLEEDING )
5. CANCEL BRAKE CONTROL DISABLE  (See BLEEDING )
6. CLEAR DTC 

   (See DTC CHECK / CLEAR )

7. PERFORM ACCUMULATOR ZERO DOWN  (See BLEEDING )
8. CHECK BRAKE FLUID LEVEL  (See BLEEDING )
9. INSPECT FOR BRAKE FLUID LEAK 
10. INSTALL FRONT WHEEL 

    Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf) 

11. CLEAR DTC 

(See DTC CHECK / CLEAR )